DigiPlus

Engine bare metal refers to the engine in a state where the engine is DigiPlusnot equipped with oil pipes, wires, auxiliary devices and other components. If you want the bare metal engine to work normally, you need to follow certain steps. The following will introduce in detail the process of the engine bare metal to the working state. Step 1: Installing the oil pipe is one of the key steps to make the engine work normally. When installing the oil pipe, one end of the oil pipe needs to be connected to the fuel supply system and the other end to the engine oil pipe joint. At this time, it is necessary to check whether the oil pipe connection is tight to avoid oil leakage caused by loose oil pipe. Step 2: Installing wires is another key step to make the engine work normally. AtWhen installing the wire, one end of the wire needs to be connected to the power supply system and the other end to the engine electrical device. At this time, it is necessary to check whether the wire connection is tight, so as to avoid loose wire failure and affect the normal operation of the engine. Step 3: Install the auxiliary device Installing the auxiliary device can make the engine have better performance and function. When installing auxiliary devices, it needs to be connected to various interfaces of the engine, such as cooling water pipes, trachea, etc. After this step, it is also necessary to check whether the connection is tight to ensure that the auxiliary device works smoothly. Step 4: After connecting the oil pipe for refueling, you need to add fuel to the fuel tank. Pay attention to the types and standards of fuel of various engines, and ensure that the engine refers to the specifications of engine oil, caloric value, etc. Before refueling, you also need to check whether the fuel filter is clean to avoid fuel contamination.Step 5: Check whether the engine oil is sufficient while refueling. At the same time, it is necessary to check whether the oil filter is clean to ensure that the engine oil is smooth and will not damage the internal parts of the engine. Step 6: The last step to start the engine bare metal to the working state is to start. Before starting the engine, it is necessary to confirm that all the connection points are firm, so as to avoid danger after starting. When starting, you should pay attention to the start-up method and time to ensure the stability of the engine. After starting, you still need to wait for a certain amount of engine preheating time to make sure that the engine is running normally before you can officially start working. In a word, the engine needs to go through many steps from bare metal to working state. Every step needs to be carefully checked and inspected to avoid engine failure due to mistakes. At the same time, when the engine is working, the relevant operating specifications should be followed to ensure work efficiency and safety.I hope this article can enlighten you and improve your understanding of the bare metal to the working state of the engine.

Contact Us
Phone：020-83484668